AM-3DP/2DP/Coating Equipment in University of Turku

Form 2 (Formlabs)
Print Technology
– Stereolithographic (SLA)
– For development and preparation of dental
prostheses, e.g., dental orthodontics,
crowns & bridges, surgical guides, dental
models, custom trays and partial dentures
– Located at TCBC at PharmaCity
Contact: lippo.lassila@utu.fi
Form 2 (Formlabs)
Turku Clinical Biomaterials Centre
https://formlabs.com/eu/3d-printers/form-2

Asiga Max UV
Print Technology
– Stereolithographic (SLA)
– For development and preparation of dental
prostheses, e.g., dental orthodontics,
crowns & bridges, surgical guides, dental
models, custom trays and partial dentures
– Located at TCBC at PharmaCity
Contact: lippo.lassila@utu.fi
Turku Clinical Biomaterials Centre
https://www.asiga.com/products/printers/max_series/max/

Form 3 (Formlabs)
Print Technology
– Low Force Stereolithographic (SLA)
Contact: ansmal@utu.fi
Molecular Plant Biology
https://formlabs.com/eu/3d-printers/form-3/

Preparation of Thin Films

Aerosol and ultrasonic deposition
equipment (laboratory made)
Surface coating systems for thin and well
controlled coatings. Both systems are totally
computer controlled.
Aerosol system
• The coating solution is sprayed on spinning
substrate
• Sequential rinsing is applied if needed
Ultrasound system
• Ultrasonic nebulizer is utilized to generate very
fine mist from coating solution
• Carrier gas (heated) is used to guide the mist on
the spinning sustrate

Vapor phase polymerization & Spin coating
Vapor phase polymerization (VPP) set with
temperature sensors and vacuum substrate holder
accessories for 0.5 x 0.5 cm to 20 x 20 cm
substrates (Flexible substrates can be used)

Laurell’s WS-650HZ-8NPPB-UD-3
SPIN PROCESSOR
(Flexible substrates can be used)

Ossila spin coater